IP175G 5 Port 10/100M Ethernet Integrated Switch
(85nm /Extreme Low Power, PWMT® and AFT®)
General Description :
IP175G is fabricated with advanced CMOS(85nm/Low Power) technology and only requires a 3.3V sinlge power supply. This feature makes IP175G consumes very low power, such as the full load operation (100Mbps_FDX x8) and embedded LDO, overall power consumption only takes 0.55w.
IP175G also supports Power Management Tool (PWMT® ) for IEEE 802.3az, APS, WOL+ and PWD for Green Power. While two link devices have no IEEE 802.3az capability, IP175G use WOL+ to change link from 100Mbps to 10Mbps for saving power.
The PWD of IP175G is designed for power down switch immediately by pushing a botton, user don’t plug out the power adapter. Push the button again, it will power on immediately.
Except Low Power and Rich Power Saving method, IP175G supports AFT® for saving Customer Testing Cost. By using a push bottom and cables, IP175G will Auto test completely by itself.
Feature :
5 port Embedded 10/100 PHY Switch Controller
Support 5 100BaseTX or 4 100Base TX + 1 FX
Support Auto MDI-MDIX function
Power Management Tool (PWMT®)
- APS, auto-power saving while Link-off
- IEEE 802.3az protocol based power saving & 10Mbps Te for 10Mbps - WOL+®, light traffic power saving
- PWD, force-off power saving
Support Auto Factory Test (AFT®)
Single Power 3.3V supply
Built in Vcore Regulator
Two Priority queues per port
Support 802.1p & DiffServ based QoS
QoS
- Port base
- 802.1p
- IP DiffServ IPV4/IPV6
- TCP/UDP port number
- Pins configure ports priority (VIP port)
Support max forwarding packet length 1552/1536 bytes option
Support port mirror function
Support 1k MAC address
Support broadcast storm protection
Support port trunking (LACP)
Support 16 VLAN (IEEE Std 802.1q)
- Port-based/Tagged-based VLAN
- Support insert, remove tag
Built-in 50 ohm resistors for simplifying BOM
85nm Process
Package and operation temperature
IP175G: 48 Pin QFN(6x6), 0~70℃
Application :
5 port 10/100 SOHO Switch
4TX+1FX Switch |
|
|